Instructions in 5 steps Stamping, cutting, decorating - simple steps for special cards. And this is how it works:
1 ![]()
Step 1
Stamp the white card B6 with the fish stamp from the wooden stamp set over a distance of about 1.5 cm from the bottom edge of the card. Use for this purpose the pink StazOn pigmented stamp pad. Let it dry well out.2 ![]()
Step 2
Then trace one fish with the Quickie Glue adhesive stick and sprinkle it with the silver ultra-fine glitter dust. Tap off loose glitter dust. Stamp two boats by means of the stone-grey StazOn stamp pad and one boat with the silver Delicata Metallic stamp pad. Then trace one grey boat with the Quickie Glue adhesive stick and sprinkle it with the silver ultra-fine glitter dust, and tap off loose glitter dust.3 ![]()
Step 3
Cut the boats out and punch a hole with the punch pliers at the top, in the middle of the boats. Stick the 3D adhesive square onto the rear side of the stamped boats. Cut 3 strands out of the silver metallic yarn of 15 cm each, and thread one boat per strand and tie a knot on the rear side of the boat. Now you can place the boats on the card. Knot the yarn ends on the inside of the card and affix them by means of the double-sided adhesive tape.4 ![]()
Step 4
Cut out a blank measuring 16.3 × 11 cm from the white B6 card. Cover all its 4 sides with the special double-sided adhesive tape. Then stick this blank to the left inner side of the card.5 ![]()
Step 5
Cut out a blank measuring 29.8 × 11.3 cm from the letterhead A4 parchment. Fold it carefully in the middle and insert it into the card.Related craft ideas Looking for similar craft ideas? You can find them here: ![]()
![Difficulty -]()
Card Boats
DIFFICULTY
