Wooden ring with plate „Elisa & Paul“

Craftideas
Wooden ring with plate „Elisa & Paul“

Difficulty

Duration

150 min

Download Idea as PDF

Share Idea

Instructions in 10 steps Pyrography newly interpreted. In combination with wood and decorative flowers and blossoms, a beautiful hanging decoration arises. And this is how it works:

Step 1

Mix the cashmere gold Extreme Sheen paint and the gold Extreme Sheen paint in a mixing ratio of 1:1, and paint the wooden ring on both sides (outer dimension: 44 cm). Let it dry out.

Step 2

Transfer your motif by means of the transfer paper onto the wooden disc.

Step 3

The motif can now be burnt with the wood burning pen.

Step 4

Drill a hole through the narrow edge of the ring with the drill, which serves as a suspension for the ring.

Step 5

Stick the flowers and the eucalyptus twig onto the wooden ring with the hot glue gun (see picture).

Step 6

Coat the wooden board with the alabaster white glaze. Let it dry out.

Step 7

Affix the double-sided adhesive tape at the edge of the wooden plate.

Step 8

Put the centre of the jute yarn onto the lower edge of the wooden plate. Stick the jute yarn to the right and the left edge of the wooden plate up to the upper middle and tie a knot.

Step 9

Place the wooden plate in the middle of the wooden ring and tie a second knot for the spacing between the wooden plate and the wooden ring. Then pull both ends through the hole of the wooden ring and knot the two ends together.

Step 10

In order to achieve a good weight distribution, stick the magnets between the flowers on the wooden ring. Finally, stick the hearts onto the wooden plate.

Used products For this craft idea, you need the following products of Rayher: