Decorative illuminated bottle “Let it snow”

Craftideas
Decorative illuminated bottle “Let it snow”

Difficulty

Duration

30 min

Download Idea as PDF

Share Idea

Instructions in 5 steps Delicately illuminated decorative glass jars are just the right thing for the cold season. Filled with decorative snowy landscape, they create a warm atmosphere.

Besides the articles listed below, you also need: bowl, cold water, Cosmetic tissue, 1x cell battery CR2032

And this is how it works:

Step 1

Clean the glass bottle with detergent and water. By means of the wet painting sponge and a drop of detergent make a foam concentrate. With this foam, the decorative peel-off motif can be applied more easily. Follow the instructions for the decorative peel-off motifs and apply accordingly the motifs to the glass bottle. Use the wooden skewer to apply a small amount of the 3D glue to the base of the fir tree.

Step 2

Then, glue the decorative fir tree and the 3 wooden shapes Deers with the 3-D glue into the glass bottle. To do this, use the tweezers and the wooden skewer. Put also a small blot splash on the feet of the deer and stick it into the glass bottle by means of the tweezers. The glue dries slowly, so do not tip the bottle over as much during further decoration. The glue dries slowly, therefore do not tilt the bottle too much during further decoration.

Step 3

Sprinkle in the decorative snowflakes and put a few decorative feathers on top.

Step 4

Insert the cell battery into the micro LED string of lights and glue it with the hot melt glue onto the lower middle of the cork lid. Wind the coated wire around the battery compartment and affix it with the hot melt glue. Coil the string of lights loosely into a spiral and then put it around the fir tree preferably spiral-shaped.

Step 5

Wind twice the gold glitter ribbon around the neck of the bottle and tie it laterally with a loop on one side. Stick a few decorative feathers to the ribbon hanging down by means of the hot melt glue and make a knot at each end.