Runder Beton-Teelichthalter

Craftideas
Runder Beton-Teelichthalter

Difficulty

Duration

60 min

Download Idea as PDF

Share Idea

Instructions in 8 steps Die Plastikhalbkugel klebst du in die runde Gießform, damit du dort später Platz für dein Teelicht hast.

Besides the articles listed below, you also need: Speiseöl, Küchenrolle, Tesa

And this is how it works:

Step 1

In preparation place adhesive tape over all small openings of the mould and remove the hanger of the plastic ball. Afterwards place the plastic ball at the bottom of the mould with the round side facing upwards.

Step 2

Oil the insides of the mould as well as the plastic ball with cooking oil.

Step 3

Mix water and creative cement in the ratio 1:10, beginning with the water in a plastic bucket and adding small portions of the creative cement. Stir the mixture with a wooden craft stick, until it is a smooth and pourable compound.

Step 4

Now pour a small amount of creative cement into the mould and with the help of a wooden spit and dab the cement around the half plastic ball, so that the cement can spread up until the edge of the ball. Fill the mould up to the desired height (at best leaving at least 1 cm to the upper edge). Let the creative cement rest for 1-2 minutes, while carefully knocking against the mould, so that possible air bubbles can escape.

Step 5

Let the cement dry. The curing time can vary, depending on the size and temperature (best let it harden over night), then demould the form and let it fully harden (do not let it harden completely in the mould. The bowl is completely hardened and can be used after 1-2 days.